I CARD COATING

Project Description

Make Enquiry

ADHESIVE RANGE

I CARD COATING
DFR 149/ DFH 244

Features

  • Clear coat
  • Medium curing system

Benefits

  • Easy to apply
  • clear

Mixing Ratio
100:50

SKU – PACK size

7.5 KG AND 7.8

Application

  • I card coating

Method of Application
Surface preparation: The adherents must be thoroughly degreased with a good degreasing solvent (e.g. toluene, acetone trichloroethylene) to remove dust, oil, water and greese to make the surface clean

Application: The mixed mass is poured on the surface.

Curing: Curing normally takes place at room temperature within about 24 hours depending on the temperature but may be accelerated by the application of heat.

Precaution
Spills and disposal: In case of spills, sweep up and shovel the spilled material. Keep spilled material in suitable, closed containers for disposal. Soak up with an absorbent such as clay, sand or other suitable material. Flush area with water to remove trace residue. Do not allow the product to reach the sewage system. Waste must be disposed of in accordance with federal, state or local regulations, as applicable.

Safety: Wear personal protective equipment (PPE). Avoid contact with the eyes and skin. In case of direct contact and irritation, it should be washed off immediately with soap and warm water. Avoid breathing vapours, mist or gas.

Make Enquiry

ADHESIVE RANGE

I CARD COATING
DFR 167/ DFH 267

Features

  • Clear coat
  • Medium curing system

Benefits

  • Easy to apply
  • clear

Mixing Ratio
100:30

SKU – PACK size

7.5 KG AND 7.8

Application

  • I card coating

Method of Application
Surface preparation: The adherents must be thoroughly degreased with a good degreasing solvent (e.g. toluene, acetone trichloroethylene) to remove dust, oil, water and greese to make the surface clean

Application: The mixed mass is poured on the surface.

Curing: Curing normally takes place at room temperature within about 24 hours depending on the temperature but may be accelerated by the application of heat.

Precaution
Spills and disposal: In case of spills, sweep up and shovel the spilled material. Keep spilled material in suitable, closed containers for disposal. Soak up with an absorbent such as clay, sand or other suitable material. Flush area with water to remove trace residue. Do not allow the product to reach the sewage system. Waste must be disposed of in accordance with federal, state or local regulations, as applicable.

Safety: Wear personal protective equipment (PPE). Avoid contact with the eyes and skin. In case of direct contact and irritation, it should be washed off immediately with soap and warm water. Avoid breathing vapours, mist or gas.